Here's a couple images with my new to me Printing Nikkor PN105mm F2.8A (thanks Ray). I used a Wemacro Vertical Stand with a Nikon D800E and PB6 Bellows. Focus rail is a modified (MJKZZ kit) THK KR20 controlled by Wemacro controller. The subject is a old 6" silicon wafer apparently with some very large test chips.
This image is a single image from the stack shot at ~1X.
Lighting was from a 8" by 3" by 9" cone made from $ Store stiff white paper and 3 strobes. I had to use hp inkjet paper as a white balance as the cheap paper cone had a ugly yellow cast. I'll be getting some better material for the cone soon to help improve the lighting....and working on the other aspects of the setup.
Anyway, think this is a good start for the PN105
BTW these look much better in full resolution.
Best,
Mike
PN105 Wafer Image
Moderators: rjlittlefield, ChrisR, Chris S., Pau
-
- Posts: 2627
- Joined: Thu Jan 17, 2013 9:34 pm
- Location: United States
- Contact: