www.photomacrography.net :: View topic - When the metal is too hard
www.photomacrography.net Forum Index
An online community dedicated to the practices of photomacrography, close-up and macro photography, and photomicrography.
Photomacrography Front Page Amateurmicrography Front Page
Old Forums/Galleries
 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 
When the metal is too hard

 
Post new topic   Reply to topic    www.photomacrography.net Forum Index -> Technical and Studio Photography -- Macro and Close-up
View previous topic :: View next topic  
Author Message
Pizzazz



Joined: 28 Nov 2013
Posts: 484

PostPosted: Fri May 22, 2020 1:50 pm    Post subject: When the metal is too hard Reply with quote

Gang

A machinist friend was tapping into a hard steel cylinder and had a few issues.

One failure through the side and one down the center. I do not know
what the fibers are. He probably wiped the surface with a cloth.

Mike






Back to top
View user's profile Send private message
Display posts from previous:   
Post new topic   Reply to topic    www.photomacrography.net Forum Index -> Technical and Studio Photography -- Macro and Close-up All times are GMT - 7 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2005 phpBB Group