Lately, I've been using a reversed Minolta manual 50mm lens reversed onto manual extension tubes.
This obviously precludes the use of DSLR Controller for focus stacking, necessitating the use of my cheap Chinese manual rail.
The problem is achieving uniform movement.
While I could zero out the rail and put a mark on the knob at 12:00, I think it would be easier to use if there were some kind of simple dial face against which to reference the mark/arrow on the knob.
Does anyone have or know about a solution for this? I have Corel Draw, so I can print a circle and gradations. I was thinking I could print it on card stock and laminate it. I could possible glue that onto thin wood, plastic or metal.
Any ideas?
Increasing Manual Rail Precision?
Moderators: rjlittlefield, ChrisR, Chris S., Pau
-
- Posts: 870
- Joined: Tue Oct 23, 2012 7:01 pm
- Location: North Olmsted, Ohio, U.S.A.
Does your rail have a standard micrometer adjustment? If so, the bottom half of the cases that writeable DVDs come in have a perfect push-fit hole in the bottom (the inside of the post that holds the DVDs). It just pushes onto the end of the micrometer handle. Maybe you have one laying around?
You hold and spin the post for quick movement, or use a fingertip on the edge for fine adjustments. I just put evenly spaced tick marks around the edge and lined those up with something on the table to gauge evenly spaced steps by eye.
You hold and spin the post for quick movement, or use a fingertip on the edge for fine adjustments. I just put evenly spaced tick marks around the edge and lined those up with something on the table to gauge evenly spaced steps by eye.
-
- Posts: 870
- Joined: Tue Oct 23, 2012 7:01 pm
- Location: North Olmsted, Ohio, U.S.A.
Yes, the rail is one of the typical X-Y focus rails.Beatsy wrote:Does your rail have a standard micrometer adjustment? If so, the bottom half of the cases that writeable DVDs come in have a perfect push-fit hole in the bottom (the inside of the post that holds the DVDs). It just pushes onto the end of the micrometer handle. Maybe you have one laying around?
You hold and spin the post for quick movement, or use a fingertip on the edge for fine adjustments. I just put evenly spaced tick marks around the edge and lined those up with something on the table to gauge evenly spaced steps by eye.
What I was thinking of was printing out a vernier scale (I found a good one) and laminating it. I'd then glue that to a disk (metal, plastic, or woord) that I would (somehow) affix to the rail, behind the knob. I could then paint/glue an indicator mark on the knob.
-
- Posts: 870
- Joined: Tue Oct 23, 2012 7:01 pm
- Location: North Olmsted, Ohio, U.S.A.
You don't know how the knobs on those generic rails come off, do you? Do they just pull off? I'm trying to avoid breaking anything I can't afford to replace.Beatsy wrote:Does your rail have a standard micrometer adjustment? If so, the bottom half of the cases that writeable DVDs come in have a perfect push-fit hole in the bottom (the inside of the post that holds the DVDs). It just pushes onto the end of the micrometer handle. Maybe you have one laying around?
-
- Posts: 870
- Joined: Tue Oct 23, 2012 7:01 pm
- Location: North Olmsted, Ohio, U.S.A.
The ones that I have don't slip over the knob.Beatsy wrote:The DVD case just slides over the standard handle without taking it off. I can't really suggest how to remove a handle without seeing it (if that's what you need to do). Sorry.
I just did a stack of 23 trying to use the linear scale. It's still processing through CombinZP.