Found: aluminium block with some tapped holes

ChrisLilley · Post by **ChrisLilley** » Tue Mar 15, 2011 10:40 am

Sonynut, thanks so much for the rapid turnaround on that order and also for including the bolts.

I just got an email from McMaster refusing my order; they don't sell to foreigners anymore.

Due to the ever-increasing complexity of U.S. Export regulations, McMaster-Carr has decided to only accept orders from a few, long-established customers of ours overseas. We will not accept your order and regret any inconvenience this causes you.

SONYNUT · Post by **SONYNUT** » Tue Mar 15, 2011 4:15 pm

yea I wasn't sure if they did, now we know..

lauriek · Post by **lauriek** » Tue Mar 15, 2011 5:42 pm

ChrisR wrote:
...around 20 usd
I think you might be very popular
I'll prepare a list...

I'm sure Chris is correct. I could do with at least a couple of doodads like this..

Sonynut I'll be sending you a PM at some point when I've thought about what I need, assuming you are cool with another request for the undoubtedly growing pile!

SONYNUT · Post by **SONYNUT** » Tue Mar 15, 2011 5:44 pm

no problem

ChrisLilley · Post by **ChrisLilley** » Tue Mar 29, 2011 3:39 pm

USPS seemed to take a while with this one but it has now arrived. The various holes match up nicely with the corresponding parts, so my macro rig moves one step closer to completion. Thanks once again to Sonynut for the fabrication of this item.

SONYNUT · Post by **SONYNUT** » Tue Mar 29, 2011 4:50 pm

YEA I was asking them yesterday..It got hung up in customs..so much for 6-10 days

glad it worked out for ya