OK, here's a weird one. I have four Zeiss Pol objectives, 4x, 8x, 16x, and 40x with RMS threads, mounted in the appropriate INKO Nomarski prisms. Those appear to have Zeiss 24mm threads, and to be screwed into spiffy little Zeiss dovetail plates.
I wish to remount them in a Nikon turret that has M26 holes. The bushing shouldn't be much of a problem. What is a problem is that I can't, for the life of me, get these dang INKOs off the little dovetail plates. Do these things actually unscrew? Are they just thoroughly stuck? Are there little set screws that I'm missing somewhere? Or is it a mega dose of Loc-Tite?
Any hints?
Zeiss INKO objectives stuck...
Moderators: rjlittlefield, ChrisR, Chris S., Pau
-
- Posts: 128
- Joined: Fri Aug 15, 2008 1:53 pm
- Location: Detroit, Michigan
-
- Posts: 128
- Joined: Fri Aug 15, 2008 1:53 pm
- Location: Detroit, Michigan
-
- Posts: 128
- Joined: Fri Aug 15, 2008 1:53 pm
- Location: Detroit, Michigan
Laurie, thank you for the suggestion.
I've tried so many things. Tightening before loosening got "covered" by trying to see if they might have been "left hand thread". I've used a sonic breaking tool, applied heat to the dovetail, and a few other tricks. I'm beginning to think they're attached with the Zeiss equivalent of Loc-Tite, because these things are stuck...
I've tried so many things. Tightening before loosening got "covered" by trying to see if they might have been "left hand thread". I've used a sonic breaking tool, applied heat to the dovetail, and a few other tricks. I'm beginning to think they're attached with the Zeiss equivalent of Loc-Tite, because these things are stuck...
- rjlittlefield
- Site Admin
- Posts: 23626
- Joined: Tue Aug 01, 2006 8:34 am
- Location: Richland, Washington State, USA
- Contact:
Hhmm, seems nobody here has a ready answer for this problem.
I wonder if you've tried asking in the Yahoo Microscope Group? That bunch often has good coverage for problems like this.
--Rik
I wonder if you've tried asking in the Yahoo Microscope Group? That bunch often has good coverage for problems like this.
--Rik
-
- Posts: 128
- Joined: Fri Aug 15, 2008 1:53 pm
- Location: Detroit, Michigan
INKO Stuck
Hi
Yes i have 3 INKO Before and 2 of them - no problem
but one was wery hard to the dovtail carrier
For that one i reassembly the adjustable dovtail and unscrew
the objectives from it , i have to take hard to get it loose , but here was no locking media in the treads
Regards
Pär Lundqvist
Sweden
Yes i have 3 INKO Before and 2 of them - no problem
but one was wery hard to the dovtail carrier
For that one i reassembly the adjustable dovtail and unscrew
the objectives from it , i have to take hard to get it loose , but here was no locking media in the treads
Regards
Pär Lundqvist
Sweden
****** Seeing is Believing ******
-
- Posts: 128
- Joined: Fri Aug 15, 2008 1:53 pm
- Location: Detroit, Michigan