Hi,
I’m a 3D artist looking to model a Zeiss Standard RA microscope. I’ve found plenty of imagery online for reference, however after a day of scouring the internet, I can’t seem to find any reliable dimensions online. I was hoping someone here on the forums with access to a Zeiss Standard RA could help me get the following dimensions:
(image below illustrating listed dimensions)
H1 - Height from bottom of base to top of stand
H2 - Height from top of base to top of block
H3 - Height from bottom of base to top of base
D1 - outer diameter of top of stand
D2 - outer diameter of nosepiece
D3 - diameter of dial
D4 - diameter of illuminator?
W1 - width of base
Any other dimensions you think would help would be greatly appreciated as well, however I think i can extrapolate everything I need from this set of dimensions.
Thanks!
Dimensions for Zeiss Standard RA
Moderators: rjlittlefield, ChrisR, Chris S., Pau
-
- Posts: 3
- Joined: Thu Jan 18, 2018 8:41 pm
The dimensions of the Zeiss RA body:
H1 - 270mm
H2 - 98 - 123mm
H3 - 40mm
D1 - 62mm
D2 - 68mm
D3 - 55mm
D4 - 55mm
W1 - 168mm at the bottom of the base but is 140mm at the top of the base
These are some measurements which you didn't ask for but may want:
L1 - 225mm This is the total length of the base, front to back, measured from the bottom but only 210mm on the top of the base.
L2 - 82mm Length of the arm on top of the base without the condenser/stage carrier.
W2 - 46mm Width of the arm at the front sitting on top of the base
H1 - 270mm
H2 - 98 - 123mm
H3 - 40mm
D1 - 62mm
D2 - 68mm
D3 - 55mm
D4 - 55mm
W1 - 168mm at the bottom of the base but is 140mm at the top of the base
These are some measurements which you didn't ask for but may want:
L1 - 225mm This is the total length of the base, front to back, measured from the bottom but only 210mm on the top of the base.
L2 - 82mm Length of the arm on top of the base without the condenser/stage carrier.
W2 - 46mm Width of the arm at the front sitting on top of the base
-
- Posts: 3
- Joined: Thu Jan 18, 2018 8:41 pm